part of the product development has been the product testing. Before releasing
the product into the market, it is necessary to perform test for its
reliability, life cycle, operational stresses, and conditions. For small
products it is possible and quite easy to do, but for products of bigger in
size and magnitude, and having long product life cycle, this process gets
costly, especially if the revisions are involved. Thus enters the need of Computer
Under CAE, the
product is put through the series of forces and environmental conditions to
simulate, the operational condition. The simulation conditions can be revised,
optimized as per the required study to be performed, and used to obtain a
domain specific result. This process saves time and cost in the long run.
several software or apps providing such services – ANSYS, using the FEA and FEM
principles to perform the simulations. In this course, you will get to learn
about the types of geometry involved in CAE, and the basic understanding of meshing
and how to perform mesh of the system. When it comes to simulation you will be
learning about the static and transient – structural and thermal simulation and
the flow simulation through a pipe.
- Calculating force across a simple 2 D plate.
- Static and Dynamic analysis of tubular chassis.
- Temperature in a rod.
- Cooling of rod with time.
- Temperature difference for heat generating conductor.
- Flow across a T section.
Types of geometries in CAE and their selection as per the goal of simulation.
Types of mesh elements.
Load setup – In structural simulation
Static vs Dynamic solver differences
Static and Dynamic Simulation
Thermal load setup and applying heat generation
Applying CFD Load setups
- Mobile/Laptop/Tablet with good internet connectivity.
- 8 Lessons
- 07:35:00 Hours
The course was very comprehensive and easy to understand. The instructor made sure that they are giving the information in a way that won't make me confused. Thank you so much for this great course!
Get latest 10 course.